This is an unpolished draft of the third edition of this e-book. If you find any error or have suggestions to improve the text, please create an issue via https://github.com/CNP3/ebook/issues?milestone=3 or help us by providing pull requests to close the existing issues.
Which are the mechanisms that should be included in a transport protocol providing an unreliable connectionless transport service that can detect transmission errors, but not correct them ?
A reliable connection oriented transport places a 32 bits sequence number inside the segment header to number the segments. This sequence number is incremented for each data segment. The connection starts as shown in the figure below :
Continue the connection so that `Host B` sends `Hello` as data and `Host A` replies by sending `Pleased to meet you`. After having received the response, `Host B` closes the connection gracefully and `Host A` does the same. Discuss on the state that needs to be maintained inside each host.
A transport connection that provides a message-mode service has been active for some time and all data has been exchanged and acknowledged in both directions. As in the exercise above, the sequence number is incremented after the transmission of each segment. At this time, `Host A` sends two DATA segments as shown in the figure below.
Consider a reliable connection-oriented transport protocol that provides the bytestream service. In this transport protocol, the sequence number that is placed inside each DATA segment reflects the position of the bytes in the bytestream. Considering the connection shown below, provide the DATA segments that are sent by `Host A` in response to the `DATA.request`, assuming that one segment is sent for each `DATA.request`.
Same question as above, but consider now that the transport protocol tries to send large DATA segments whenever possible. For this exercise, we consider that a DATA segment can contain up to 8 bytes of data in the payload. Do not forget to show the acknowledgments in your answer.
Consider a transport protocol that provides a reliable connection-oriented bytestream service. You observe the segments sent by a host that uses this protocol. Does the time-sequence diagram below reflects a valid implementation of this protocol ? Justify your answer.
In the above example, the two `DATA` segments were lost before arriving at the destination. Discuss the following scenario and explain how the receiver should react to the reception of the last `DATA` segment.
A network layer service guarantees that a packet will never live during more than 100 seconds inside the network. Consider a reliable connection-oriented transport protocol that places a 32 bits sequence number inside each segment. What is the maximum rate (in segments per second) at which is should sent data segments to prevent having two segments with the same sequence number inside the network ?
Amazon provides the `S3 storage service <https://s3.amazonaws.com/>`_ where companies and researchers can store lots of information and perform computations on the stored information. Amazon allows users to send files through the Internet, but also by sending hard-disks. Assume that a 1 Terabyte hard-disk can be delivered within 24 hours to Amazon by courier service. What is the minimum bandwidth required to match the bandwidth of this courier service ?
In the transport layer, the receive window advertised by a receiver can vary during the lifetime of the connection. What are the causes for these variations ?
A reliable connection-oriented protocol can provide a message-mode service or a byte stream service. Which of the following usages of the sequence numbers is the best suited for each of these services ?
