Zen

Translation

TCP connections with a small round-trip-time can achieve a higher throughput than TCP connections having a longer round-trip-time when losses occur. This implies that the TCP congestion control scheme is not completely fair since it favors the connections that have the shorter round-trip-times.
0/2950 · 295

Sign in to save translations.

English French Actions
The `CWR` bit of the TCP header provides some form of acknowledgment for the `ECE` bit. When a TCP receiver detects a packet marked with the `CE` bit, it sets the `ECE` bit in all segments that it returns to the sender. Upon reception of an acknowledgment with the `ECE` bit set, the sender reduces its congestion window to reflect a mild congestion and sets the `CWR` bit. This bit remains set as long as the segments received contained the `ECE` bit set. A sender should only react once per round-trip-time to marked packets.
 
The last point that needs to be discussed about Explicit Congestion Notification is the algorithm that is used by routers to detect congestion. On a router, congestion manifests itself by the number of packets that are stored inside the router buffers. As explained earlier, we need to distinguish between two types of routers :
 
routers that have a single FIFO queue
 
routers that have several queues served by a round-robin scheduler
 
Routers that use a single queue measure their buffer occupancy as the number of bytes of packets stored in the queue [#fslot]_. A first method to detect congestion is to measure the instantaneous buffer occupancy and consider the router to be congested as soon as this occupancy is above a threshold. Typical values of the threshold could be 40% of the total buffer. Measuring the instantaneous buffer occupancy is simple since it only requires one counter. However, this value is fragile from a control viewpoint since it changes frequently. A better solution is to measure the *average* buffer occupancy and consider the router to be congested when this average occupancy is too high. Random Early Detection (RED) [FJ1993]_ is an algorithm that was designed to support Explicit Congestion Notification. In addition to measuring the average buffer occupancy, it also uses probabilistic marking. When the router is congested, the arriving packets are marked with a probability that increases with the average buffer occupancy. The main advantage of using probabilistic marking instead of marking all arriving packets is that flows will be marked in proportion of the number of packets that they transmit. If the router marks 10% of the arriving packets when congested, then a large flow that sends hundred packets per second will be marked 10 times while a flow that only sends one packet per second will not be marked. This probabilistic marking allows marking packets in proportion of their usage of the network resources.
 
If the router uses several queues served by a scheduler, the situation is different. If a large and a small flow are competing for bandwidth, the scheduler will already favor the small flow that is not using its fair share of the bandwidth. The queue for the small flow will be almost empty while the queue for the large flow will build up. On routers using such schedulers, a good way of marking the packets is to set a threshold on the occupancy of each queue and mark the packets that arrive in a particular queue as soon as its occupancy is above the configured threshold.
 
Modeling TCP congestion control
 
Thanks to its congestion control scheme, TCP adapts its transmission rate to the losses that occur in the network. Intuitively, the TCP transmission rate decreases when the percentage of losses increases. Researchers have proposed detailed models that allow the prediction of the throughput of a TCP connection when losses occur [MSMO1997]_ . To have some intuition about the factors that affect the performance of TCP, let us consider a very simple model. Its assumptions are not completely realistic, but it gives us good intuition without requiring complex mathematics.
 
Evolution of the congestion window with regular losses
 
As the losses are equally spaced, the congestion window always starts at some value (:math:`\frac{W}{2}`), and is incremented by one MSS every round-trip-time until it reaches twice this value (`W`). At this point, a segment is retransmitted and the cycle starts again. If the congestion window is measured in MSS-sized segments, a cycle lasts :math:`\frac{W}{2}` round-trip-times. The bandwidth of the TCP connection is the number of bytes that have been transmitted during a given period of time. During a cycle, the number of segments that are sent on the TCP connection is equal to the area of the yellow trapeze in the figure. Its area is thus :
 
:math:`area=(\frac{W}{2})^2 + \frac{1}{2} \times (\frac{W}{2})^2 = \frac{3 \times W^2}{8}`
 
However, given the regular losses that we consider, the number of segments that are sent between two losses (i.e. during a cycle) is by definition equal to :math:`\frac{1}{p}`. Thus, :math:`W=\sqrt{\frac{8}{3 \times p}}=\frac{k}{\sqrt{p}}`. The throughput (in bytes per second) of the TCP connection is equal to the number of segments transmitted divided by the duration of the cycle :
 
:math:`Throughput=\frac{area \times MSS}{time} = \frac{ \frac{3 \times W^2}{8}}{\frac{W}{2} \times rtt}` or, after having eliminated `W`, :math:`Throughput=\sqrt{\frac{3}{2}} \times \frac{MSS}{rtt \times \sqrt{p}}`
 
More detailed models and the analysis of simulations have shown that a first order model of the TCP throughput when losses occur was :math:`Throughput \approx \frac{k \times MSS}{rtt \times \sqrt{p}}`. This is an important result which shows that :
 
TCP connections with a small round-trip-time can achieve a higher throughput than TCP connections having a longer round-trip-time when losses occur. This implies that the TCP congestion control scheme is not completely fair since it favors the connections that have the shorter round-trip-times.
 
TCP connections that use a large MSS can achieve a higher throughput that the TCP connections that use a shorter MSS. This creates another source of unfairness between TCP connections. However, it should be noted that today most hosts are using almost the same MSS, roughly 1460 bytes.
 
In general, the maximum throughput that can be achieved by a TCP connection depends on its maximum window size and the round-trip-time if there are no losses. If there are losses, it depends on the MSS, the round-trip-time and the loss ratio.
 
:math:`Throughput<\min(\frac{window}{rtt},\frac{k \times MSS}{rtt \times \sqrt{p}})`
 
The TCP congestion control zoo
 
The first TCP congestion control scheme was proposed by `Van Jacobson`_ in [Jacobson1988]_. In addition to writing the scientific paper, `Van Jacobson`_ also implemented the slow-start and congestion avoidance schemes in release 4.3 `Tahoe` of the BSD Unix distributed by the University of Berkeley. Later, he improved the congestion control by adding the fast retransmit and the fast recovery mechanisms in the `Reno` release of 4.3 BSD Unix. Since then, many researchers have proposed, simulated and implemented modifications to the TCP congestion control scheme. Some of these modifications are still used today, e.g. :
 
`NewReno` (:rfc:`3782`), which was proposed as an improvement of the fast recovery mechanism in the `Reno` implementation.
 
`TCP Vegas`, which uses changes in the round-trip-time to estimate congestion in order to avoid it [BOP1994]_. This is one of the examples of the delay-based congestion control algorithms. A Vegas sender continuously measures the evolution of the round-trip-time and slows down when the round-trip-time increases significantly. This enables Vegas to prevent congestion when used alone. Unfortunately, if Vegas senders compete with more aggressive TCP congestion control schemes that only react to losses, Vegas senders may have difficulties to user their fair share of the available bandwidth.
 
`CUBIC`, which was designed for high bandwidth links and is the default congestion control scheme in Linux since the Linux 2.6.19 kernel [HRX2008]_. It is now used by several operating systems and is becoming the default congestion control scheme :rfc:`8312`. A key difference between CUBIC and the TCP congestion control scheme described in this chapter is that CUBIC is much more aggressive when probing the network. Instead of relying on additive increase after a fast recovery, a CUBIC sender adjusts its congestion by using a cubic function. Thanks to this function, the congestion windows grows faster. This is particularly important in high-bandwidth delay networks.
 
`BBR`, which is being developed by Google researchers and is included in recent Linux kernels [CCG+2016]_. BBR periodically estimates the available bandwidth and the round-trip-times. To adapt to changes in network conditions, BBR regularly tries to send at 1.25 times the current bandwidth. This enables BBR senders to probe the network, but can also cause large amount of losses. Recent scientific articles indicate that BBR is unfair to other congestion control schemes in specific conditions [WMSS2019]_.
 
A wide range of congestion control schemes have been proposed in the scientific literature and several of them have been widely deployed. A detailed comparison of these congestion control schemes is outside the scope of this chapter. A recent survey paper describing many of the implemented TCP congestion control schemes may be found in [TKU2019]_.
 
Footnotes
 
In this pseudo-code, we assume that TCP uses unlimited sequence and acknowledgment numbers. Furthermore, we do not detail how the `cwnd` is adjusted after the retransmission of the lost segment by fast retransmit. Additional details may be found in :rfc:`5681`.
 
In enterprise networks or datacenters, the situation is different since a single company typically controls all the sources and all the routers. In such networks it is possible to ensure that all hosts and routers have been upgraded before turning on ECN on the routers.
 
With the ECT bit, the deployment issue with ECN is solved provided that all sources cooperate. If some sources do not support ECN but still set the ECT bit in the packets that they sent, they will have an unfair advantage over the sources that correctly react to packet markings. Several solutions have been proposed to deal with this problem :rfc:`3540`, but they are outside the scope of this book.
 
The buffers of a router can be implemented as variable or fixed-length slots. If the router uses variable length slots to store the queued packets, then the occupancy is usually measured in bytes. Some routers have use fixed-length slots with each slot large enough to store a maximum-length packet. In this case, the buffer occupancy is measured in packets.
 

Loading…

User avatar None

Source string added
TCP connections with a small round-trip-time can achieve a higher throughput than TCP connections having a longer round-trip-time when losses occur. This implies that the TCP congestion control scheme is not completely fair since it favors the connections that have the shorter round-trip-times.
4 years ago
Browse all string changes

Glossary

English French
No related strings found in the glossary.

30873 String information

Source string location
../../protocols/congestion.rst:211
String age
4 years ago
Last updated
2 months ago
Source string age
4 years ago
Translation file
locale/fr/LC_MESSAGES/protocols/congestion.po, string 42