Exit Zen
70
../../principles/network.rst:325
English
The packet is too large and router `R1` cannot forward it to router `R2`. It rejects the packet and sends a control packet back to the source (host `A`) to indicate that it cannot forward packets longer than 500 bytes (minus the packet header). The source could react to this control packet by retransmitting the information in smaller packets.
0/3440 · 344
70
../../principles/reliability.rst:246
English
`NUL`: `0000000` b
0/180 · 18
70
../../principles/sharing.rst:283
English
Limited resources need to be shared in other environments than Local Area Networks. Since the first radio transmissions by `Marconi <http://en.wikipedia.org/wiki/Guglielmo_Marconi>`_ more than one century ago, many applications that exchange information through radio signals have been developed. Each radio signal is an electromagnetic wave whose power is centered around a given frequency. The radio spectrum corresponds to frequencies ranging between roughly 3 KHz and 300 GHz. Frequency allocation plans negotiated among governments reserve most frequency ranges for specific applications such as broadcast radio, broadcast television, mobile communications, aeronautical radio navigation, amateur radio, satellite, etc. Each frequency range is then subdivided into channels and each channel can be reserved for a given application, e.g. a radio broadcaster in a given region.
0/8800 · 880
70
../../principles/transport.rst:231
English
The `connectionless service` that we have described earlier is frequently used by users who need to exchange small SDUs. It can be easily built on top of the connectionless network layer service that we have described earlier. Users needing to either send or receive several different and potentially large SDUs, or who need structured exchanges often prefer the `connection-oriented service`.
0/3930 · 393
71
../../glossary.rst:164
English
The Interior Gateway Routing Protocol (IGRP) is a proprietary intradomain routing protocol that uses distance vector. IGRP supports multiple metrics for each route but has been replaced by :term:`EIGRP`
0/2020 · 202
71
../../principles/network.rst:327
English
The network layer is able to fragment a packet. In our example, the router could fragment the packet in two parts. The first part contains the beginning of the payload and the second the end. There are two possible ways to perform this fragmentation.
0/2500 · 250
71
../../principles/reliability.rst:247
English
`BEL`: `0000111` b
0/180 · 18
71
../../principles/sharing.rst:288
English
`Frequency Division Multiplexing` (FDM) is a static allocation scheme in which a frequency is allocated to each device attached to the shared medium. As each device uses a different transmission frequency, collisions cannot occur. In optical networks, a variant of FDM called `Wavelength Division Multiplexing` (WDM) can be used. An optical fiber can transport light at different wavelengths without interference. With WDM, a different wavelength is allocated to each of the devices that share the same optical fiber.
0/5170 · 517
71
../../principles/transport.rst:234
English
The connection-oriented service
0/310 · 31
72
../../glossary.rst:195 • ../../glossary.rst:259
English
IMAP
0/100 · 4
72
../../principles/reliability.rst:248
English
`CR` : `0001101` b
0/180 · 18
72
../../principles/sharing.rst:293
English
`Time Division Multiplexing` (TDM) is a static bandwidth allocation method that was initially defined for the telephone network. In the fixed telephone network, a voice conversation is usually transmitted as a 64 Kbps signal. Thus, a telephone conservation generates 8 KBytes per second or one byte every 125 microseconds. Telephone conversations often need to be multiplexed together on a single line. For example, in Europe, thirty 64 Kbps voice signals are multiplexed over a single 2 Mbps (E1) line. This is done by using `Time Division Multiplexing` (TDM). TDM divides the transmission opportunities into slots. In the telephone network, a slot corresponds to 125 microseconds. A position inside each slot is reserved for each voice signal. The figure below illustrates TDM on a link that is used to carry four voice conversations. The vertical lines represent the slot boundaries and the letters the different voice conversations. One byte from each voice conversation is sent during each 125 microseconds slot. The byte corresponding to a given conversation is always sent at the same position in each slot.
0/11150 · 1115
73
../../principles/network.rst:332
English
Each of the packet fragments is a valid packet that contains a header with the source (host `A`) and destination (host `B`) addresses. When router `R2` receives a packet fragment, it treats this packet as a regular packet and forwards it to its final destination (host `B`). Host `B` reassembles the received fragments.
0/3190 · 319
73
../../principles/reliability.rst:249
English
`LF` : `0001010` b
0/180 · 18
73
../../principles/transport.rst:241
English
The establishment of a connection can be modeled by using four primitives : `Connect.request`, `Connect.indication`, `Connect.response` and `Connect.confirm`. The `Connect.request` primitive is used to request the establishment of a connection. The main parameter of this primitive is the `address` of the destination user. The service provider delivers a `Connect.indication` primitive to inform the destination user of the connection attempt. If it accepts to establish a connection, it responds with a `Connect.response` primitive. At this point, the connection is considered to be established and the destination user can start sending SDUs over the connection. The service provider processes the `Connect.response` and will deliver a `Connect.confirm` to the user who initiated the connection. The delivery of this primitive terminates the connection establishment phase. At this point, the connection is considered to be open and both users can send SDUs. A successful connection establishment is illustrated below.
0/10210 · 1021
74
../../glossary.rst:261
English
The Internet Message Access Protocol (IMAP), defined in :rfc:`3501`, is an application-level protocol that allows a client to access and manipulate the emails stored on a server. With IMAP, the email messages remain on the server and are not downloaded on the client.
0/2670 · 267
74
../../principles/network.rst:335
English
These three solutions have advantages and drawbacks. With the first solution, routers remain simple and do not need to perform any fragmentation operation. This is important when routers are implemented mainly in hardware. However, hosts must be complex since they need to store the packets that they produce if they need to pass through a link that does not support large packets. This increases the buffering required on the hosts.
0/4330 · 433
74
../../principles/reliability.rst:250
English
`DLE`: `0010000` b
0/180 · 18
74
../../principles/sharing.rst:303
English
TDM as shown above can be completely static, i.e. the same conversations always share the link, or dynamic. In the latter case, the two endpoints of the link must exchange messages specifying which conversation uses which byte inside each slot. Thanks to these control messages, it is possible to dynamically add and remove voice conversations from a given link.
0/3620 · 362
74
../../principles/transport.rst:262
English
The example above shows a successful connection establishment. However, in practice not all connections are successfully established. One reason is that the destination user may not agree, for policy or performance reasons, to establish a connection with the initiating user at this time. In this case, the destination user responds to the `Connect.indication` primitive by a `Disconnect.request` primitive that contains a parameter to indicate why the connection has been refused. The service provider will then deliver a `Disconnect.indication` primitive to inform the initiating user.
0/5870 · 587