Exit Zen
75
../../principles/reliability.rst:251
English
`STX`: `0000010` b
0/180 · 18
75
../../principles/transport.rst:283
English
A second reason is when the service provider is unable to reach the destination user. This might happen because the destination user is not currently attached to the network or due to congestion. In these cases, the service provider responds to the `Connect.request` with a `Disconnect.indication` primitive whose `reason` parameter contains additional information about the failure of the connection.
0/4010 · 401
76
../../glossary.rst:71
English
a public internet, i.e. a network composed of different networks that are running :term:`IPv4` or :term:`IPv6`
0/1100 · 110
76
../../principles/network.rst:339
English
Fragmenting packets on a per-link basis, as presented for the second solution, can minimize the transmission overhead since a packet is only fragmented on the links where fragmentation is required. Large packets can continue to be used downstream of a link that only accepts small packets. However, this reduction of the overhead comes with two drawbacks. First, fragmenting packets, potentially on all links, increases the processing time and the buffer requirements on the routers. Second, this solution leads to a longer end-to-end delay since the downstream router has to reassemble all the packet fragments before forwarding the packet.
0/6410 · 641
76
../../principles/reliability.rst:252
English
`ETX`: `0000011` b
0/180 · 18
76
../../principles/sharing.rst:309
English
ALOHA
0/100 · 5
76
../../principles/transport.rst:303
English
Once the connection has been established, the service provider supplies two data streams to the communicating users. The first data stream can be used by the initiating user to send SDUs. The second data stream allows the responding user to send SDUs to the initiating user. The data streams can be organized in different ways. A first organization is the `message-mode` transfer. With the `message-mode` transfer, the service provider guarantees that one and only one `Data.indication` will be delivered to the endpoint of the data stream for each `Data.request` primitive issued by the other endpoint. The `message-mode` transfer is illustrated in the figure below. The main advantage of the `message-transfer` mode is that the recipient receives exactly the SDUs that were sent by the other user. If each SDU contains a command, the receiving user can process each command as soon as it receives a SDU.
0/9050 · 905
77
../../glossary.rst:72
English
internet
0/100 · 8
77
../../principles/network.rst:341
English
The last solution is a compromise between the two others. Routers need to perform fragmentation but they do not need to reassemble packet fragments. Only the hosts need to have buffers to reassemble the received fragments. This solution has a lower end-to-end delay and requires fewer processing time and memory on the routers.
0/3270 · 327
77
../../principles/reliability.rst:254
English
Some characters are used as markers to delineate the frame boundaries. Many `character stuffing` techniques use the `DLE`, `STX` and `ETX` characters of the ASCII character set. `DLE STX` (resp. `DLE ETX`) is used to mark the beginning (end) of a frame. When transmitting a frame, the sender adds a `DLE` character after each transmitted `DLE` character. This ensures that none of the markers can appear inside the transmitted frame. The receiver detects the frame boundaries and removes the second `DLE` when it receives two consecutive `DLE` characters. For example, to transmit frame `1 2 3 DLE STX 4`, a sender will first send `DLE STX` as a marker, followed by `1 2 3 DLE`. Then, the sender transmits an additional `DLE` character followed by `STX 4` and the `DLE ETX` marker.
0/7810 · 781
77
../../principles/transport.rst:338
English
Unfortunately, the `message-mode` transfer is not widely used on the Internet. On the Internet, the most popular connection-oriented service transfers SDUs in `stream-mode`. With the `stream-mode`, the service provider supplies a byte stream that links the two communicating users. The sending user sends bytes by using `Data.request` primitives that contain sequences of bytes as SDUs. The service provider delivers SDUs containing consecutive bytes to the receiving user by using `Data.indication` primitives. The service provider ensures that all the bytes sent at one end of the stream are delivered correctly in the same order at the other endpoint. However, the service provider does not attempt to preserve the boundaries of the SDUs. There is no relation enforced by the service provider between the number of `Data.request` and the number of `Data.indication` primitives. The `stream-mode` is illustrated in the figure below. In practice, a consequence of the utilization of the `stream-mode` is that if the users want to exchange structured SDUs, they will need to provide the mechanisms that allow the receiving user to separate successive SDUs in the byte stream that it receives. Application layer protocols often use specific delimiters such as the end of line character to delineate SDUs in a bytestream.
0/13190 · 1319
78
../../glossary.rst:74
English
an internet is an internetwork, i.e. a network composed of different networks. The :term:`Internet`, with a capital `I` corresponds to the global network that we use today, but other internetworks have been used in the path.
0/2240 · 224
78
../../principles/network.rst:343
English
The first solution to the fragmentation problem presented above suggests the utilization of control packets to inform the source about the reception of a too long packet. This is only one of the functions that are performed by the control protocol in the network layer. Other functions include :
0/2950 · 295
78
../../principles/reliability.rst:260
English
**1** **2** **3** **4**
0/230 · 23
79
../../glossary.rst:304
English
inverse query
0/130 · 13
79
../../principles/network.rst:345
English
sending a control packet back to the source if a packet is received by a router that does not have a valid entry in its forwarding table
0/1360 · 136
79
../../principles/reliability.rst:260
English
`DLE STX` **1** **2** **3** **4** `DLE ETX`
0/430 · 43
79
../../principles/transport.rst:409
English
An abrupt connection release can also be triggered by one of the users. If a user needs, for any reason, to terminate a connection quickly, it can issue a `Disconnect.request` primitive and to request an abrupt release. The service provider will process the request, stop the two data streams and deliver the `Disconnect.indication` primitive to the remote user as soon as possible. As illustrated in the figure below, this abrupt connection release may cause losses of SDUs.
0/4750 · 475
80
../../glossary.rst:306
English
For DNS servers and resolvers, an inverse query is a query for the domain name that corresponds to a given IP address.
0/1180 · 118
80
../../principles/network.rst:346
English
sending a control packet back to the source if a router detects that a packet is looping inside the network
0/1070 · 107