Exit Zen
42
../../protocols/congestion.rst:211
English
TCP connections with a small round-trip-time can achieve a higher throughput than TCP connections having a longer round-trip-time when losses occur. This implies that the TCP congestion control scheme is not completely fair since it favors the connections that have the shorter round-trip-times.
0/2950 · 295
43
../../protocols/congestion.rst:212
English
TCP connections that use a large MSS can achieve a higher throughput that the TCP connections that use a shorter MSS. This creates another source of unfairness between TCP connections. However, it should be noted that today most hosts are using almost the same MSS, roughly 1460 bytes.
0/2850 · 285
44
../../protocols/congestion.rst:214
English
In general, the maximum throughput that can be achieved by a TCP connection depends on its maximum window size and the round-trip-time if there are no losses. If there are losses, it depends on the MSS, the round-trip-time and the loss ratio.
0/2420 · 242
45
../../protocols/congestion.rst:216
English
:math:`Throughput<\min(\frac{window}{rtt},\frac{k \times MSS}{rtt \times \sqrt{p}})`
0/840 · 84
46
../../protocols/congestion.rst:219
English
The TCP congestion control zoo
0/300 · 30
47
../../protocols/congestion.rst:221
English
The first TCP congestion control scheme was proposed by `Van Jacobson`_ in [Jacobson1988]_. In addition to writing the scientific paper, `Van Jacobson`_ also implemented the slow-start and congestion avoidance schemes in release 4.3 `Tahoe` of the BSD Unix distributed by the University of Berkeley. Later, he improved the congestion control by adding the fast retransmit and the fast recovery mechanisms in the `Reno` release of 4.3 BSD Unix. Since then, many researchers have proposed, simulated and implemented modifications to the TCP congestion control scheme. Some of these modifications are still used today, e.g. :
0/6220 · 622
48
../../protocols/congestion.rst:223
English
`NewReno` (:rfc:`3782`), which was proposed as an improvement of the fast recovery mechanism in the `Reno` implementation.
0/1220 · 122
49
../../protocols/congestion.rst:224
English
`TCP Vegas`, which uses changes in the round-trip-time to estimate congestion in order to avoid it [BOP1994]_. This is one of the examples of the delay-based congestion control algorithms. A Vegas sender continuously measures the evolution of the round-trip-time and slows down when the round-trip-time increases significantly. This enables Vegas to prevent congestion when used alone. Unfortunately, if Vegas senders compete with more aggressive TCP congestion control schemes that only react to losses, Vegas senders may have difficulties to user their fair share of the available bandwidth.
0/5930 · 593
50
../../protocols/congestion.rst:225
English
`CUBIC`, which was designed for high bandwidth links and is the default congestion control scheme in Linux since the Linux 2.6.19 kernel [HRX2008]_. It is now used by several operating systems and is becoming the default congestion control scheme :rfc:`8312`. A key difference between CUBIC and the TCP congestion control scheme described in this chapter is that CUBIC is much more aggressive when probing the network. Instead of relying on additive increase after a fast recovery, a CUBIC sender adjusts its congestion by using a cubic function. Thanks to this function, the congestion windows grows faster. This is particularly important in high-bandwidth delay networks.
0/6730 · 673
51
../../protocols/congestion.rst:226
English
`BBR`, which is being developed by Google researchers and is included in recent Linux kernels [CCG+2016]_. BBR periodically estimates the available bandwidth and the round-trip-times. To adapt to changes in network conditions, BBR regularly tries to send at 1.25 times the current bandwidth. This enables BBR senders to probe the network, but can also cause large amount of losses. Recent scientific articles indicate that BBR is unfair to other congestion control schemes in specific conditions [WMSS2019]_.
0/5080 · 508
52
../../protocols/congestion.rst:229
English
A wide range of congestion control schemes have been proposed in the scientific literature and several of them have been widely deployed. A detailed comparison of these congestion control schemes is outside the scope of this chapter. A recent survey paper describing many of the implemented TCP congestion control schemes may be found in [TKU2019]_.
0/3490 · 349
53
../../protocols/congestion.rst:235
English
Footnotes
0/100 · 9
54
../../protocols/congestion.rst:236
English
In this pseudo-code, we assume that TCP uses unlimited sequence and acknowledgment numbers. Furthermore, we do not detail how the `cwnd` is adjusted after the retransmission of the lost segment by fast retransmit. Additional details may be found in :rfc:`5681`.
0/2610 · 261
55
../../protocols/congestion.rst:238
English
In enterprise networks or datacenters, the situation is different since a single company typically controls all the sources and all the routers. In such networks it is possible to ensure that all hosts and routers have been upgraded before turning on ECN on the routers.
0/2700 · 270
56
../../protocols/congestion.rst:240
English
With the ECT bit, the deployment issue with ECN is solved provided that all sources cooperate. If some sources do not support ECN but still set the ECT bit in the packets that they sent, they will have an unfair advantage over the sources that correctly react to packet markings. Several solutions have been proposed to deal with this problem :rfc:`3540`, but they are outside the scope of this book.
0/4000 · 400
57
../../protocols/congestion.rst:242
English
The buffers of a router can be implemented as variable or fixed-length slots. If the router uses variable length slots to store the queued packets, then the occupancy is usually measured in bytes. Some routers have use fixed-length slots with each slot large enough to store a maximum-length packet. In this case, the buffer occupancy is measured in packets.
0/3580 · 358
The translation has come to an end.