cnp3-ebook/protocols/ipv6 — English @ Weblate

Exit Zen

57 ../../protocols/ipv6.rst:189

	English There is one difficulty with the utilization of these IPv6 prefixes. Consider Belnet, the Belgian research ISP that has been allocated the ``2001:6a8::/32`` prefix. Universities are connected to Belnet. UCLouvain uses prefix ``2001:6a8:3080::/48`` while the University of Liege uses ``2001:6a8:2d80::/48``. A commercial ISP uses prefix ``2a02:2788::/32``. Both Belnet and the commercial ISP are connected to the global Internet. 429/10000 · 429
58 ../../protocols/ipv6.rst:196

	English The Belnet network advertises prefix ``2001:6a8::/32`` that includes the prefixes from both UCLouvain and ULg. These two subnetworks can be easily reached from any internet connected host. After a few years, UCLouvain decides to increase the redundancy of its Internet connectivity and buys transit service from ISP1. A direct link between UCLouvain and the commercial ISP appears on the network and UCLouvain expects to receive packets from both Belnet and the commercial ISP. 477/10000 · 477
59 ../../protocols/ipv6.rst:199

	English Now, consider how a router inside ``alpha.com`` would reach a host in the ``UCLouvain`` network. This router has two routes towards ``2001:6a8:3080::1``. The first one, for prefix ``2001:6a8:3080::/48`` is via the direct link between the commercial ISP and UCLouvain. The second one, for prefix ``2001:6a8::/32`` is via the Internet and Belnet. Since :rfc:`1519` when a router knows several routes towards the same destination address, it must forward packets along the route having the longest prefix length. In the case of ``2001:6a8:3080::1``, this is the route ``2001:6a8:3080::/48`` that is used to forward the packet. This forwarding rule is called the `longest prefix match` or the `more specific match`. All IP routers implement this forwarding rule. 758/10000 · 758
60 ../../protocols/ipv6.rst:201

	English To understand the `longest prefix match` forwarding, consider the IPv6 routing below. 85/10000 · 85
61 ../../protocols/ipv6.rst:214

	English With the longest match rule, the route ``::/0`` plays a particular role. As this route has a prefix length of `0` bits, it matches all destination addresses. This route is often called the `default` route. 205/10000 · 205
62 ../../protocols/ipv6.rst:216

	English a packet with destination ``2a02:2788:2c4:16f::1`` received by router `R` is destined to a host on interface ``eth0`` . 119/10000 · 119
63 ../../protocols/ipv6.rst:217

	English a packet with destination ``2001:6a8:3080::1234`` matches three routes : ``::/0``, ``2001:6a8::/32`` and ``2001:6a8:3080::/48``. The packet is forwarded via gateway ``fe80::bad:cafe`` 183/10000 · 183
64 ../../protocols/ipv6.rst:218

	English a packet with destination ``2001:1890:123a::1:1e`` matches one route : ``::/0``. The packet is forwarded via ``fe80::dead:beef`` 128/10000 · 128
65 ../../protocols/ipv6.rst:219

	English a packet with destination ``2001:6a8:3880:40::2`` matches two routes : ``2001:6a8::/32`` and ``::/0``. The packet is forwarded via ``fe80::aaaa:bbbb`` 150/10000 · 150
66 ../../protocols/ipv6.rst:225

	English The longest prefix match can be implemented by using different data structures One possibility is to use a trie. Details on how to implement efficient packet forwarding algorithms may be found in [Varghese2005]_. 212/10000 · 212
67 ../../protocols/ipv6.rst:230

	English For the companies that want to use IPv6 without being connected to the IPv6 Internet, :rfc:`4193` defines the `Unique Local Unicast (ULA)` addresses (``fc00::/7``). These ULA addresses play a similar role as the private IPv4 addresses defined in :rfc:`1918`. However, the size of the ``fc00::/7`` address block allows ULA to be much more flexible than private IPv4 addresses. 375/10000 · 375
68 ../../protocols/ipv6.rst:234

	English Furthermore, the IETF has reserved some IPv6 addresses for a special usage. The two most important ones are : 109/10000 · 109
69 ../../protocols/ipv6.rst:236

	English ``0:0:0:0:0:0:0:1`` (``::1`` in compact form) is the IPv6 loopback address. This is the address of a logical interface that is always up and running on IPv6 enabled hosts. 171/10000 · 171
70 ../../protocols/ipv6.rst:237

	English ``0:0:0:0:0:0:0:0`` (``::`` in compact form) is the unspecified IPv6 address. This is the IPv6 address that a host can use as source address when trying to acquire an official address. 184/10000 · 184
71 ../../protocols/ipv6.rst:241

	English The last type of unicast IPv6 addresses are the `Link Local Unicast` addresses. These addresses are part of the `fe80::/10` address block and are defined in :rfc:`4291`. Each host can compute its own link local address by concatenating the `fe80::/64` prefix with the 64 bits identifier of its interface. Link local addresses can be used when hosts that are attached to the same link (or local area network) need to exchange packets. They are used notably for address discovery and auto-configuration purposes. Their usage is restricted to each link and a router cannot forward a packet whose source or destination address is a link local address. Link local addresses have also been defined for IPv4 :rfc:`3927`. However, the IPv4 link local addresses are only used when a host cannot obtain a regular IPv4 address, e.g. on an isolated LAN. 841/10000 · 841
72 ../../protocols/ipv6.rst:259

	English All IPv6 hosts have several addresses 37/10000 · 37
73 ../../protocols/ipv6.rst:261

	English An important consequence of the IPv6 unicast addressing architecture and the utilization of link-local addresses is that each IPv6 host has several IPv6 addresses. This implies that all IPv6 stacks must be able to handle multiple IPv6 addresses. 245/10000 · 245
74 ../../protocols/ipv6.rst:265

	English The addresses described above are unicast addresses. These addresses are used to identify (interfaces on) hosts and routers. They can appear as source and destination addresses in the IPv6 packets. When a host sends a packet towards a unicast address, this packet is delivered by the network to its final destination. There are situations, such as when delivering video or television signal to a large number of receivers, where it is useful to have a network that can efficiently deliver the same packet to a large number of receivers. This is the `multicast` service. A multicast service can be provided in a LAN. In this case, a multicast address identifies a set of receivers and each frame sent towards this address is delivered to all receivers in the group. Multicast can also be used in a network containing routers and hosts. In this case, a multicast address identifies also a group of receivers and the network delivers efficiently each multicast packet to all members of the group. Consider for example the network below. 1033/10000 · 1033
75 ../../protocols/ipv6.rst:289

	English Assume that ``B`` and ``D`` are part of a multicast group. If ``A`` sends a multicast packet towards this group, then ``R1`` will replicate the packet to forward it to ``R2`` and ``R3``. ``R2`` would forward the packet towards ``B``. ``R3`` would forward the packet towards ``R4`` that would deliver it to ``D``. 312/10000 · 312
76 ../../protocols/ipv6.rst:291

	English Finally, :rfc:`4291` defines the structure of the IPv6 multicast addresses [#fmultiiana]_. This structure is depicted in the figure below. 138/10000 · 138

Shortcut	Action
`?`	Open available keyboard shortcuts.
`Alt` + `Home`	Navigate to the first translation in the current search.
`Alt` + `End`	Navigate to the last translation in the current search.
`Alt` + `PageUp` or `Ctrl` + `↑` or `Alt` + `↑` or `Cmd` + `↑` or	Navigate to the previous translation in the current search.
`Alt` + `PageDown` or `Ctrl` + `↓` or `Alt` + `↓` or `Cmd` + `↓` or	Navigate to the next translation in the current search.
`Ctrl` + `Enter` or `Cmd` + `Enter`	Submit current form; this works the same as pressing Save and continue while editing translation.
`Ctrl` + `Shift` + `Enter` or `Cmd` + `Shift` +`Enter`	Unmark translation as Needing edit and submit it.
`Alt` + `Enter` or `Option` + `Enter`	Submit the string as a suggestion; this works the same as pressing Suggest while editing translation.
`Ctrl` + `E` or `Cmd` + `E`	Focus on translation editor.
`Ctrl` + `U` or `Cmd` + `U`	Focus on comment editor.
`Ctrl` + `M` or `Cmd` + `M`	Shows Automatic suggestions tab.
`Ctrl` + `1` to `Ctrl` + `9` or `Cmd` + `1` to `Cmd` + `9`	Copies placeable of a given number from source string.
`Ctrl` + `M` followed by `1` to `9` or `Cmd` + `M` followed by `1` to `9`	Copy the machine translation of a given number to current translation.
`Ctrl` + `I` followed by `1` to `9` or `Cmd` + `I` followed by `1` to `9`	Ignore one item in the list of failing checks.
`Ctrl` + `J` or `Cmd` + `J`	Shows the Nearby strings tab.
`Ctrl` + `S` or `Cmd` + `S`	Focus on search field.
`Ctrl` + `O` or `Cmd` + `O`	Copy the source string.
`Ctrl` + `Y` or `Cmd` + `Y`	Toggle the Needs editing checkbox.
`→`	Browse the next translation string.
`←`	Browse the previous translation string.