Exit Zen
36
../../protocols/rpc.rst:122
English
`data`: an optional field that provides additional information about the error.
0/790 · 79
37
../../protocols/rpc.rst:124
English
Coming back to our example with the call for the `sum` procedure, it would return the following JSON structure.
0/1110 · 111
38
../../protocols/rpc.rst:131
English
If the `sum` method is not implemented on the server, it would reply with the following response.
0/970 · 97
39
../../protocols/rpc.rst:138
English
The `id` field, which is present in the request and the response plays the same role as the identifier field in the DNS message. It allows the caller to match the response with the request that it sent. This `id` is very important when JSON-RPC is used over the connectionless transport service which is unreliable. If a request is sent, it may need to be retransmitted and it is possible that a callee will receive twice the same request (e.g. if the response for the first request was lost). In the DNS, when a request is lost, it can be retransmitted without causing any difficulty. However with remote procedure calls in general, losses can cause some problems. Consider a method which is used to deposit money on a bank account. If the request is lost, it will be retransmitted and the deposit will be eventually performed. However, if the response is lost, the caller will also retransmit its request. This request will be received by the callee that will deposit the money again. To prevent this problem from affecting the application, either the programmer must ensure that the remote procedures that it calls can be safely called multiple times or the application must verify whether the request has been transmitted earlier. In most deployments, the programmers use remote methods that can be safely called multiple times without breaking the application logic.
0/13710 · 1371
40
../../protocols/rpc.rst:146
English
ONC-RPC uses a more complex method to allow a caller to reach the callee. On a host, server processes can run on different ports and given the limited number of port values (:math:`2^{16}` per host on the Internet), it is impossible to reserve one port number for each method. The solution used in ONC-RPC :rfc:`1831` is to use a special method which is called the `portmapper` :rfc:`1833`. The `portmapper` is a kind of directory that runs on a server that hosts methods. The `portmapper` runs on a standard port (`111` for ONC-RPC :rfc:`1833`). A server process that implements a method registers its method on the local `portmapper`. When a caller needs to call a method on a remote server, it first contacts the `portmapper` to obtain the port number of the server process which implements the method. The response from the portmapper allows it to directly contact the server process which implements the method.
0/9160 · 916
41
../../protocols/rpc.rst:151
English
Footnotes
0/100 · 9
The translation has come to an end.